Rashed's Way2SAPBASIS.com

Hi All,
I was conneting to three real system into one single group with one Domain and other two real systems under the group,I was able to connet one domain and one real system but, when i wanted to add third system, i had an error i.e the third system which i wanted to be other real system in the group by configuring it by STMS it say you have logon to the domain controller.This was even after deleting the domain controller (i.e even deleting the TMS configurations) in that system and then reconfiguring the TMS,if any solution for this pls assist.

If i am wrong pls correct me.

Sangeeth Kumar.

hi sangeet,

check if the system is pro configured as domain controller.and also just by doing DICO will not remove the comple configuration u need to remove ur profiles for TMS from /usr/sap/trans /bin

regards
pavan

Hi Pavan,
Tried even afetr deleting the the profile from that system and also tried to create the RFC's for the Systems.But the system which i am trying to the configure doesn't have any other the TMs configured in that particular system.Is there any other possiblity to go on doing it from the starting.

Any suggestion would be helpful for me.

Thanks n Regards,
Sangy.

BASIS24x7 wrote:hi sangeet,

check if the system is pro configured as domain controller.and also just by doing DICO will not remove the comple configuration u need to remove ur profiles for TMS from /usr/sap/trans /bin

regards
pavan

Domain controller should be ur Development system.
AND also delete the file from usr/sap/trans/bin.


regards
Venkat